Showing 11–20 of 66 results
-

$158.52 – $261.11Price range: $158.52 through $261.11
9-1/2” Barrel repair kit for Janus Model 650, 750, 1000 and 1950 roll-up doors with 1” axle. Includes: Tube, drum, springs, mounting brackets, axle, ratchet tensioner and fasteners (excluding Model 1950).
-

$8.80 – $22.00Price range: $8.80 through $22.00
Pull rope for Model 650 and manual/push-up doors under 10′. This product is sold by the foot. Please round up to the nearest whole foot when ordering. (For example, if your measurement is 4ft 6in, order 5ft.)
-

$38.96
Please round up to the nearest whole foot when ordering. (For example, if your measurement is 4ft 6in, order 5ft.) Sold as a pair Comes with one left-hand and one right-hand 12 GA commercial mounting brackets Deep embossing for strength Independently tested to withstand more than 1,200 pounds per pair Rounded edges allow for easy…
-

$487.14
ONLY AVAILABLE WITH NEW DOOR PURCHASES – Commercial vision panel option available on Janus Model 2000 and 2500 door when purchased before manufacturing. Vision panels are 5” x 17” and mounted at the standard height of 52-1/2” from floor to bottom of vision panel. Panels are limited by door widths listed below: 3’9” – 7’2”…
-

$92.80
This is a special sprocket that mounts to the drum of the roll up door when you want to add a side mounted garage door opener and your rolling steel door is equipped with a dead axle. That means this is an E/O Kit used for Janus International rolling steel doors that have a shaft…
-

$8.53
Commercial head stops for Model 1000 doors and up. Sold as a pair.
-

$65.76
Complete hardware kit for manual/push up commercial doors. Please round up to the nearest whole foot when ordering. (For example, if your measurement is 4ft 6in, order 5ft.)
-

$281.97
Complete hardware kits with reduced drive chain hoist kit for commercial doors. Please round up to the nearest whole foot when ordering. (For example, if your measurement is 4ft 6in, order 5ft.)
-

$155.88
Complete hardware kits with electric operator kit for electric openers on commercial doors. Please round up to the nearest whole foot when ordering. (For example, if your measurement is 4ft 6in, order 5ft.)
-

$4.10
This product is a 1-1/2-inch-wide single-sided adhesive felt strip sold in increments of 10 feet. It attaches to the back of the curtain to keep steel from rolling up on steel. Also used on the back of mini latches. It can be cut to specified length with scissors.
End of content
End of content